Wasp-bar-code Wasp WPL606 Manual do Utilizador

WPL606 Thermal Label Printer User’s Guide For Wasp Technologies DT/TT Printer  Copyright Wasp Bar Code Technologies 2004.

LCD display shows “Carriage Open” and the red Error light will come on. After closing the print head lift lever, the On-Line light will blink. Press t

3. Set Up 3.1 Setting Up the Printer 1. Place the printer on a flat, secure surface 2. Make sure the POWER switch is off 3. Connect the printer to

Figure 6: Ribbon under Pint Had 6. Pull the paper core up to the rewind spindle and slide it on. Slide both the ribbon and rewind spindle all the way

3.3 Label Roll Installation 1. Open the printer panels and the print head lift lever 2. Rotate the Label Guide clockwise away from the Media Guide

3.4 Peel-off Sensor Installation (Sold Separately) 1. Turn the printer off 2. Open the lower front panel 3. Snap the peel-off sensor onto the bar

3.5 Loading Label For Peel-off Mode 1. Open the front and top printer doors 2. Open the print head left lever 3. Pull several inches of labels ou

3.6 Self-test To initiate the self-test mode, press the MENU button to advance the selection to Printer Test. Press the EXE button to enter the subm

Hex decimal data related to left column of ASCII data ASCII Data Figure 18: Printout of dump mode 13

4. Calibration There are two power-on button combinations to initialize the printer settings and to calibrate sensors on the W606. 4.1 Printer Initia

To initialize the printer: 1. Turn off the printer power 2. Hold down the PAUSE and FEED buttons and turn on the printer power 3. Release the buttons

CONTENTS 1. Product Introduction ...1 1.1 Specification ...

4.3 Troubleshooting Guide The following guide lists the most common problems that may be encountered when operating this bar code printer. If the prin

5. Printer Maintenance The printer should be cleaned regularly to maintain high quality printing. 5.1 Cleaning the Print Head 1. Switch of

6. Support and Warranty 6.1 Product Support If you experience any problems with your Wasp printer that you are unable to resolve, use our online sup

Appendix 1: LCD Control Panel Operation Map 1. Print Setup0~999 (*0)Auto. RibbonManual BlineAuto Bline2. Sensor Calib.SpeedAuto. GapCutter Batch* Tear

Country* 87* NoneParityData BitOddEvenBaud2* 1Stop Bit(s)57600560003840019200*960048002400Restore DefaultsExitAvail. MemoryFile List4. File Mngment DR

Appendix 1: LCD Control Panel Operation Map...19 3

1. Product Introduction Thank you for purchasing the W606 bar code printer. This guide will describe all of the common operations needed to operate an

1.1.4 Bar Code Code 39, Code 93, Code128 subsets A B and C, Code 11, Codabar, Interleaved 2 of 5, EAN-8, EAN-13, EAN-128, UPC-A, UPC-E, EAN, UPC, EAN

2. Getting Started 2.1 Unpacking and Inspection After receiving the bar code printer, carefully inspect the device and its packaging. The printer is

External Label Feed Opening Centronics Port Figure 2: Printer rear view RS-232C Port Power Switch Power Supply Connector Print Head Lift L

2.4 Buttons, Indicators and adjustment knobs Power Indicator When the printer is in the power-on state, the Power indicator is lit. On-Line In