Wasp-bar-code WPL305 Manual do Utilizador

WPL305 Thermal Label PrinterUser’s GuideFor Wasp TechnologiesDT/TT Printer Copyright Wasp Bar Code Technologies 2004.All rights reserved.No part of t

4. Power on UtilitiesThere are three power-on utilities to set up and test printer hardware.1. Printer initialization2. Ribbon sensor calibration3.

4.3 Gap/Black Mark CalibrationGap/black mark sensor sensitivity should be calibrated at the followingconditions:1. A brand new printer2. Change labe

The printer will enter dump mode after printing the printer configuration. Indump mode, all characters will be printed in 2 columns as in the figure b

5. Maintenance5.1 CleaningUse one or more of the following supplies that meets your needs:n Cleaning pensn Cleaning swabsn Lint-free clothPrinter P

Utilities.6.2 Print QualityContinuous feeding labelsn The printer settings may be wrong. Please do the Initialization andGap/Black Mark Calibration.N

7. Specifications7.1 Printer SpecificationsItem W305MechanismResolution 203 dpi.Max. Print Width 108 mm.Max. Print Length 1000 mm ( 39” ).Ribbon Capac

Wound Type Outside wound.Width 20mm ~ 112mm (0.78” ~ 4.4”).Length 10mm ~ 1000mm (0.4” ~ 39”).25.4mm ~ 1000mm (1” ~ 39”).(for peeler and cutter)Thickne

This warranty is limited to repair or replacement at Wasp Technologies’ option, withreasonable promptness after being notified. These provisions do no

1. Introduction ...12. Getting Started...

1. IntroductionThank you for purchasing the W305 Thermal Transfer and Direct Thermal BarCode Printer. Although the printer takes only a small amount o

2.3 Printer PartsFigure 1: Top front view3. Setup3.1 Setting Up the Printer1. Place the printer on a flat, secure surface.2. Make sure the power switc

ribbon, please refer to the ribbon calibration procedure to calibrate the ribbonsensor.NOTE: If you are using direct thermal labels you should not loa

Make sure both the ribbon access window and the printer top cover areclosed when powering up the printer.3.3 Loading Label Stock1. Insert a 1” label

Figure 6: Label installation4. Feed the paper, printing side face up, under the Teflon bar and the paperguide and pass over the platen.5. Adjust the

Figure 7: Top cover support is fixed at position 24. To close the cover, lift up the top cover to the ultimate angle then close thetop cover gently a

Figure 9: Use both hands to close the top cover5. Do not force the cover! If you are not sure if top cover is locked at a stopposition, please do no